Post by wrightwoodwork on Jun 14, 2014 3:08:35 GMT -5
Just being looking through the catalogue. The saws that pivot at the bottom of the F rails are the, kss400, kss400/36v, kss 80 Ec / 370, mt 55 cc, and the k85 / k85ec. The ms55, ms55/36v, ksp55, ksp65, ksp85 ksp55/36v these saws pivot on a single point where the other saws pivot point moves along the base allowing them to cut along the rubber line on the tracks. The kss300 and ksp40 there cut line is either their base or the flexi guide. The mks130, mks145 / mks165, mks185. On the Erika saws when I tilt the the blade the center if the blade is always in the center of kerf so when I tilt to 45 the cut line is approximately 1.5mm different than at 90 as the kerf that the blade makes is wider
abdon: I stand corrected , the angle fence is only attaches with F -Tracks , what confused me was , that the Timberwolf site mentioned it will work with the NFU machine, yes it will work but only I guess when you use the Ftrack , with other tracks Like the KSS L.
Nov 28, 2020 22:52:01 GMT -5
glynnco: Did you order from GereedschapPro? I see them as in stock but I'm located in the US and am not sure if they ship here. I sent them an email asking about shipping but it was returned undeliverable...
Dec 10, 2020 7:37:40 GMT -5
jonathan: I've purchased a lot of stuff from our neighbours @ GereedschapPro.nl As far as I know they are one of the larger Mafell dealers in the EU. I can recommend them, they usually respond quickly.
Dec 11, 2020 13:58:36 GMT -5
NFU 50 Transportation?: Hi Guys, is there some Systainer for the NFU 50?
Dec 11, 2020 14:30:12 GMT -5
frezik24: Hello everyone
Dec 13, 2020 9:20:00 GMT -5
lasse: Thanks for the tip! I have own a mafell rail which is 160 cm and one that is 80 cm. Will it work just as well or will I need to buy rail that is 110 cm?
Mar 18, 2021 15:35:15 GMT -5