ramin
New Member
Posts: 31
|
Post by ramin on Sept 23, 2022 11:59:28 GMT -5
Hello, Is there a way to (micro)adjust the table top to the saw blade? The left leaf of the saw is slightly lower than the right side. It's not that big of an issue but I'd like to know if there is a way to remedy this and get it absolutely perfect.
|
|
|
Post by aas on Sept 23, 2022 12:57:45 GMT -5
You don't sat what model, I'm assuming an 85.
Is it lower all the way along from front to back?.. or in the middle?
|
|
ramin
New Member
Posts: 31
|
Post by ramin on Sept 23, 2022 14:14:01 GMT -5
You don't sat what model, I'm assuming an 85. Is it lower all the way along from front to back?.. or in the middle? I have a 70. it dips in one corner.
|
|
|
Post by aas on Sept 24, 2022 0:25:22 GMT -5
A bit weird to be dipping in one corner - has it always been like that?.. has it been dropped?
There is no adjustment as far as I am aware. If you look at the Mafell service catalog you can see the basic construction. I would unbolt the front and back rails, remove the top, then shim until it is level and put it back together. I have done a similar thing on a cheaper saw in the past and it worked out well.
|
|
ramin
New Member
Posts: 31
|
Post by ramin on Sept 24, 2022 2:23:07 GMT -5
A bit weird to be dipping in one corner - has it always been like that?.. has it been dropped? There is no adjustment as far as I am aware. If you look at the Mafell service catalog you can see the basic construction. I would unbolt the front and back rails, remove the top, then shim until it is level and put it back together. I have done a similar thing on a cheaper saw in the past and it worked out well. no never dropped, it has always been like that I guess. I'll see if I can find the manual to unbolt the table top. Thanks!
|
|