andey
New Member
Posts: 19
|
Post by andey on May 28, 2016 8:14:59 GMT -5
|
|
|
Post by Eoj on May 28, 2016 9:11:14 GMT -5
Hey andey , the Mafell hose has a locking hose end to the vac . Will need to replace this part , the Festool 27mm link works on the Mafell hose supplied with the S35 M .
|
|
andey
New Member
Posts: 19
|
Post by andey on May 28, 2016 21:36:27 GMT -5
Hey andey , the Mafell hose has a locking hose end to the vac . Will need to replace this part , the Festool 27mm link works on the Mafell hose supplied with the S35 M . Hi Eoj, thanks for the reply. Looks easy enough to replace based on the video. I'll try to search for a bosch/parallel equivalent or 3d print it as festool and mafell are not sold in singapore.
|
|
|
Post by reflector on May 28, 2016 23:02:01 GMT -5
I use a Shopvac Professional 5872510 with my Cv06 mini and I connect the 1.5" Shopvac hose into the inlet which is loose fitting by pushing a small piece of solid shelf liner into the inlet as a roll then I invert the outside so it doesn't get sucked in over time. It seems to be a pretty solid connection and fully seals the hose. Otherwise the supplied hose I use to hook up my table saw with.
Quick and fast solution might be to do something like that where you pad the inlet with something that's soft and will seal so you can put the smaller diameter of the Mafell hose into the cyclone with a full seal.
|
|