|
Post by limitedtime on May 24, 2023 9:54:43 GMT -5
Installed new micro-fence and Freud blade. Will be calibrating the scales for new blade kerf. I like the setup stiffness and accuracy. Question: any experience recalibrating the scales - can they be adjusted? Replaced?
|
|
|
Post by aas on May 24, 2023 13:25:39 GMT -5
If you're talking about the scales in the front of the saw, I seem to recall they are crimped in place... might be thinking of another though. But if you are using the saw setup like the photo, just adjust the extension rails scale to line up.
Out of interest, what kerf blade are you using?
|
|
|
Post by limitedtime on May 24, 2023 13:37:45 GMT -5
If you're talking about the scales in the front of the saw, I seem to recall they are crimped in place... might be thinking of another though. But if you are using the saw setup like the photo, just adjust the extension rails scale to line up. Out of interest, what kerf blade are you using? Using Freud blade with 3.2mm nominal kerf (mics at 3.22mm) Yes, can adjust the extension rails for kerf allowance. Will be doing some test rips to dial that in (prelims indicate about a 0.6mm variance). Just annoying that the default scales are set only for kerf of Mafell blades and not adjustable. One more engineering suggestion!
|
|