|
Post by whiskymac on Oct 8, 2016 15:25:16 GMT -5
Hi all,
Just bought a new MT55 to replace my ageing TS55, build quality seems superb. The only thing I've noticed is when pulling the switch back to engage the 1 deg bevel operation...my indicator doesn't reach the 1 deg mark....points somewhere between 0 deg and 1 deg. Anyone else's saw like this, is it normal?
If it's supposed to go to 1 deg I'll get the saw swapped for another (it hasn't been used yet).
Thanks.
|
|
|
Post by GhostFist on Oct 9, 2016 4:34:42 GMT -5
If you look on the base of the saw, there are two adjustment screws to set the saw to exactly -1°. Mine was set fine out of the box but I'd try tweaking those. Doesn't seem like anything is broken
|
|