I'm thinking of making a MFT3 type top and would like to attach a Bosch rail for the 400 via some sort of hinge. Does anyone have the ability to accurately measure the size of T-bolt I would need? Has anyone built their own table using extrusions?
Thanks. Exactly what I had in mind. Where you've fixed your profiles I was going to use 18mm x 150mm strips of ply and then fix the the profiles to the ply but your way would be just as stable but lighter. Where did you get the profiles from?what clamps etc?
Today I made a worktop of sorts out of 18mm MDF and used the lr32 system to locate the holes accurately. How accurate remains to be seen as I'm awaiting some bench-dogs. I'll put a 50mm rip of 18mm ply on edge around the outside underneath albeit set back 30mm. Hopefully this will give it some rigidity and allow room for me to be able to fix 3060 extrusions at a later date.
I would like to get some T-bolts on order to try and fix a Bosch rail to some sort of flip-down rail-guide like the Festool one but don't know the dimensions of the slot on the rail.
Tymbian, I'll measure the slot later today. There are some Kreg T bolts that fit, but I couldn't find them down here. I have some 'rail dogs' that suit the Mafell rails, and the T bolt that comes with them is just a standard T bolt that has had the head ground down in thickness.
abdon: I stand corrected , the angle fence is only attaches with F -Tracks , what confused me was , that the Timberwolf site mentioned it will work with the NFU machine, yes it will work but only I guess when you use the Ftrack , with other tracks Like the KSS L.
Nov 28, 2020 22:52:01 GMT -5
glynnco: Did you order from GereedschapPro? I see them as in stock but I'm located in the US and am not sure if they ship here. I sent them an email asking about shipping but it was returned undeliverable...
Dec 10, 2020 7:37:40 GMT -5
jonathan: I've purchased a lot of stuff from our neighbours @ GereedschapPro.nl As far as I know they are one of the larger Mafell dealers in the EU. I can recommend them, they usually respond quickly.
Dec 11, 2020 13:58:36 GMT -5
NFU 50 Transportation?: Hi Guys, is there some Systainer for the NFU 50?
Dec 11, 2020 14:30:12 GMT -5
frezik24: Hello everyone
Dec 13, 2020 9:20:00 GMT -5
lasse: Thanks for the tip! I have own a mafell rail which is 160 cm and one that is 80 cm. Will it work just as well or will I need to buy rail that is 110 cm?
Mar 18, 2021 15:35:15 GMT -5