Wow! Toolstop.co.uk lowered the price of the Bosch guide rail kit to $133.70 + $47.50 shipping to the US. The Goog13 code that kalas mentioned gets you another 5% off the rail. Total shipped is $174.97 . This is for two 1600 rails, one rail connector, and rail bag. As I mentioned earlier in this thread, the same setup from Mafell is $426.50 + shipping... that's over 60% off!
I'm wondering if I got the last rail set from toolstop. I got mine Friday and they are now listed as "not currently in stock". I finally pulled the trigger on the kss300 and figured at that price, it wouldn't hurt to be able to do a non-beveled cut longer than 4'. I'm not going to do it right away, but I figure I'll eventually get a MT55.
I guess it was actually the Friday before last. Anyway, I love the KSS300. First off, I don't know how David did it, but I got it in only 2 days. Just in time to install some laminate. Since then I've done another laminate job and a small hardwood floor. This thing is great! I haven't used the parallel guide yet for rips, but I think I've used all the other functions. One of reasons I was wanting the TS55REQ rather than the MT55 was for the shadow cuts. Well, it probably makes more sense on the kss300. I used it to cut a bunch of drywall up to allow for floor expansion. Makes quick work and not much mess. I debated for a long time because it's so much money for a DIY'r, but boy is it nice.
The more you use it the more you'll love it. Should be fine for non beveled cuts on the rigid track. Word of advice, pay attention to sag in the roll up flextrack as the track cuts very easily....trust me
abdon: I stand corrected , the angle fence is only attaches with F -Tracks , what confused me was , that the Timberwolf site mentioned it will work with the NFU machine, yes it will work but only I guess when you use the Ftrack , with other tracks Like the KSS L.
Nov 28, 2020 22:52:01 GMT -5
glynnco: Did you order from GereedschapPro? I see them as in stock but I'm located in the US and am not sure if they ship here. I sent them an email asking about shipping but it was returned undeliverable...
Dec 10, 2020 7:37:40 GMT -5
jonathan: I've purchased a lot of stuff from our neighbours @ GereedschapPro.nl As far as I know they are one of the larger Mafell dealers in the EU. I can recommend them, they usually respond quickly.
Dec 11, 2020 13:58:36 GMT -5
NFU 50 Transportation?: Hi Guys, is there some Systainer for the NFU 50?
Dec 11, 2020 14:30:12 GMT -5
frezik24: Hello everyone
Dec 13, 2020 9:20:00 GMT -5
lasse: Thanks for the tip! I have own a mafell rail which is 160 cm and one that is 80 cm. Will it work just as well or will I need to buy rail that is 110 cm?
Mar 18, 2021 15:35:15 GMT -5