tazio
New Member
Posts: 18
|
Post by tazio on Oct 31, 2021 5:56:08 GMT -5
Hello there I am considering an Erica . however i noted the Erica now comes with just the mfa but not the rip fence ! so on my panel saw at the moment if I want to say break down a sheet initially using my mafell track saw to say 1200x900mm and then cut the panel into 300x900 strips ..useing the panel saw by setting up the rip fence as the stop at 300mm obviously in the slid back away from the blade then I simple put the sheet on the table push it up to the fence and slide it through then simple repeat to create the 900x300 strips !. On the mafell to have this repeatable ability would I position the mfa on the right side of the blade using as a rip fence and then use the pull facility to cut the strips or simple push the penal through against the fence ?. I can’t also quite work out how with longer sheets and the sliding table set up you are able to create repeatable strips of a panal without some sort of stop on the right side of the blade if the rip fence has been discontinued!. I have watched some of the videos but none really show this !.
|
|
|
Post by alvychippy on Oct 31, 2021 12:26:43 GMT -5
Do you mind to link up where from, what exactly model it is, as I've noticed everything still available, but with "accessories", not just plain saw alone.
|
|
|
Post by alvychippy on Oct 31, 2021 12:32:47 GMT -5
|
|
|
Post by Tom Gensmer on Oct 31, 2021 16:24:57 GMT -5
Tazio, I'd suggest that you start with just the core ERIKA package, plus a 1m MFA fence.
For larger panels, I'd suggest using your track saw of choice along with TSO squares and/or parallel guides. "Take the small thing to the big thing..."
|
|