|
Post by naildrivingman on Feb 18, 2020 21:15:59 GMT -5
i just noticed today that the LED will start bright and then flicker a few times and ultimately dim down about 25% or so. The light does not regain full brightness during the cut. As far as I can tell, the light “resets” once the trigger is released and reengaged.
has anyone else noticed this?
|
|
|
Post by aas on Feb 19, 2020 2:46:03 GMT -5
Does it tie in with motor load?
|
|
|
Post by naildrivingman on Feb 19, 2020 19:24:08 GMT -5
Does it tie in with motor load? Yes it does and it appears to happen when the battery is partially discharged. I did not notice the dimming with a full battery. It seems strange, because an led draws so little current.
|
|
|
Post by aas on Feb 20, 2020 12:27:27 GMT -5
I'll try to remember to have a look at mine. What Ah batteries are you using? I've found the 5,5's are very good for high drain tools.
|
|
|
Post by naildrivingman on Feb 20, 2020 19:39:10 GMT -5
I'll try to remember to have a look at mine. What Ah batteries are you using? I've found the 5,5's are very good for high drain tools. I’m running Metabo 8.0 Ah batteries. I have four batts. I will observe each for similar behavior.
|
|