|
Post by birdhunter on Jul 30, 2019 5:59:19 GMT -5
I think I have figured out all the attachments that came in my DDF40 Sustainer except one.
It's a red plastic thing that obviously fits around the vertical fence adjustment posts. It has embossed print that indicates 19mm.
I've looked at all the videos I can find and, in one, it's lying on a table, but not used in the video.
What it is for?
|
|
curious
New Member
EVA 150E, UVA 115E, P1cc, KSS80ec, MT55 18B bl, MKS 130ec, Erika 85, DDF40
Posts: 4
|
Post by curious on Jul 31, 2019 7:02:45 GMT -5
Do you mean this? Look at 14:30 minute.
|
|
|
Post by birdhunter on Jul 31, 2019 20:00:37 GMT -5
Yes, I’ve seen the video, but I still cannot understand what the device is supposed to do.
|
|
|
Post by birdhunter on Aug 4, 2019 5:04:18 GMT -5
Here is what. I received from Timberwolf
Here is a Video of it being used. Rahmenverbindung mit dem DuoDübler DDF 40
And here’s the instructions from page 26 of the Manual:
5.11 Drilling with position indicator PAZ according to tracing (drilling of longitudinal parts, e.g. drilling of frames) The distance can be infinitely adjusted between 19 and 60 mm to the drill axis. -Unfasten the wing nut 2 (Fig. 1) -Use the setting wheel 5 (Fig. 1) to move the tilting stop 7 (Fig. 1) to the very top. -Fit the position indicator PAZ 26 (Fig. 7) onto the columns of the height guide. -Slide the position indicator in the direction of tilting stop 7 until it engages at the tilting stop. -Set the tilting stop 7 (Fig. 1) to the desired scale value using the setting wheel 5 (Fig. 1). -Retighten the wing nut 2. -The distance between the position indicator PAZ and the centre of the drill hole corresponds to the set distance of the contact surface of the tilting stop 7 (Fig. 8). -Use the additional stop "N" on the tilting stop for right-angled alignment to the longitudinal edge of the workpiece.
Hope this helps!
|
|
|
Post by newuser on Aug 28, 2021 5:02:01 GMT -5
Just in case anyone still wondering (the above text didn’t quite penetrate here) the attachment allows you to line it up with your mark so that you can vertically align the heads when the machine is working flat and can’t make use of the height adjustment. The 19mm indicates that this is the minimum working height.
|
|