iban
Full Member
Posts: 111
|
Post by iban on Jan 31, 2021 3:46:56 GMT -5
CS50 and MFT are not easily linkable I think. It must be done by some DIY formula How did you link the mw1000 table to the cs?
|
|
|
Post by aas on Feb 1, 2021 1:45:12 GMT -5
It hooks over with a plastic bracket. I'm not sure you need the CS50 and MFT to be linked... the MW1000 has one pair of legs so needs to be attached.
|
|
iban
Full Member
Posts: 111
|
Post by iban on Feb 10, 2021 16:21:57 GMT -5
Ordered the CS 50!
|
|
|
Post by henrun on Apr 17, 2021 6:53:14 GMT -5
Super late to the party and I agree with Aas. The CS50 is the more sensible choice.
I have the OF2200 in the CMS table and being able to share accessories is great as well as the outfeed tables available.
I also purchased two MW1000 tables and secure them with a clamp underneath and this makes it possible to run very long pieces when routing or trimming trim.
Much as I like the Erika 60 if I would do it all over again I would choose the CS50 for the add ons and snag a few blades when they have a promo. Sometimes they offer three blades at a decent price. The blades last a long time so I don't mind the cost even though it would be nice to have a "sacrificial cheap blade" as is possible with the Erika 60 - but you can use an older Festool blade for that if needs be.
|
|
|
Post by aas on Apr 17, 2021 12:19:41 GMT -5
Super late to the party and I agree with Aas. The CS50 is the more sensible choice. I have the OF2200 in the CMS table and being able to share accessories is great as well as the outfeed tables available. I also purchased two MW1000 tables and secure them with a clamp underneath and this makes it possible to run very long pieces when routing or trimming trim. Much as I like the Erika 60 if I would do it all over again I would choose the CS50 for the add ons and snag a few blades when they have a promo. Sometimes they offer three blades at a decent price. The blades last a long time so I don't mind the cost even though it would be nice to have a "sacrificial cheap blade" as is possible with the Erika 60 - but you can use an older Festool blade for that if needs be. How are you clamping the MW1000 on?.. I just 'hang' mine on the end of the CS50, fully aware that's it's not super safe. Would like a CMS too, but stocks seem to have dried up now production has stopped.
|
|
|
Post by henrun on Apr 18, 2021 6:15:41 GMT -5
I wiggle it in place with that plastic bracket and then clamp underneath from one alu frame to the other. Especially with the CMS/Router I have one at either end and for edge banding I have the Felder Forca 200 in a MFT table with the MW1000 as an outfeed table. Works great. I will see if I can post a photo.
|
|
|
Post by henrun on Apr 18, 2021 6:28:56 GMT -5
Photo turned out really small, can't reupload at the moment.
|
|