|
Post by kraftt on May 5, 2018 11:38:46 GMT -5
|
|
|
Post by aas on May 6, 2018 11:39:53 GMT -5
As an on site sheet cutting table, it looks OK - not sure about all the add in squares though. I couldn't see prices on the 'Translated home page', and it wasn't clear if the assistant in the last photo comes with the table or not!
|
|
|
Post by kraftt on May 6, 2018 12:31:31 GMT -5
My thoughts exactly.
I'd like to see it without the deep notches, slightly smaller holes in case you cut over them. If it's truly lightweight I might prefer it to two sawhorses for quick general purpose table. btw - looks like he's painted the multiply black, I saw some paint runs, so it's not a factory lam finish.
Nothing engineering wise difficult about it, i.e. no plans needed to make my own.
|
|
|
Post by holmz on May 6, 2018 15:39:23 GMT -5
... 'Translated home page'... Most businesses have policies or slogans like, "The customer always comes first"
|
|
|
Post by huntsgemein on Jun 6, 2018 1:45:14 GMT -5
I know some of the demonstrators stood on the framework. Even in the middle. But it still looks too flimsy for my liking. I'd far prefer a slightly-not-so lightweight &/or portable table that could double as a sturdy, secure work platform too.
Every space-wasting bit of apparatus that you cart around to mobile worksites must earn its keep in a multitude of ways. The bigger, heavier or bulkier it is, the more necessary it is to be versatile and multitasking.
|
|