ramin
New Member
Posts: 31
|
Post by ramin on Jan 4, 2020 7:38:30 GMT -5
Hello I just got the sliding table for the Erika 70 and I'm having a very hard time adjusting it properly. I already managed to snap one of the brackets because I overtightened the lower height adjustment screw. But it doesn't affect the workings of the table. It just makes it a bit harder to adjust properly. I can't get it level with my table saw because the adjustment screws don't give me enough room for adjustment. The screws only let me tilt the table upwards. But as you can see in the picture --> link there is a gap in the middle that can only be solved by tilting the table downwards, but the tilting screws are completely loose and I can't tilt it down any further than that. Any way to solve this?
|
|
|
Post by aas on Jan 4, 2020 12:13:29 GMT -5
Does it need to be that precise?.. the wood will be moving on the Erika table, you want it to run parallel.
|
|
ramin
New Member
Posts: 31
|
Post by ramin on Jan 4, 2020 13:16:57 GMT -5
Does it need to be that precise?.. the wood will be moving on the Erika table, you want it to run parallel. Indeed I've been using it now and if I make sure the wood is referencing the Erika table I'm not noticing any problems so far.
|
|
|
Post by bicycleclip on Jan 4, 2020 13:31:19 GMT -5
You can do it if you loosen the dark bolts first, then use the silver bolts (with double nuts) to adjust to level.
|
|